B&Q plc, Chandlers Ford, Hampshire, SO53 3YX.
Visit us at www.diy.com
That’s the single Wardrobe Combi Pack completed.
Take care of your unit by using a damp cloth to clean it.
Fit the Hinge Covers F306
over the Hinges.
Recycling – the packaging materials for this
product may be recycled through your local
recycling centre. When you want to dispose of
the product itself, please consider donating it
to a local charitable organisation, otherwise
recycle it through your local recycling centre.
F676
Recycling –
the packaging materials for this product may be recycled through your local recycling centre. When you want to dispose
of the product itself, please consider donating it to a local charitable organisation, otherwise recycle it through your local recycling centre.
ensure your unit
is level before you
attempt to fit your
doors.
Fitting of Drawers to Unit
7
Turn the drawer over and locate the wheels on
the drawer over the wheels fitted in the unit and
push into position.
Fitting of Soft Close Bracket to Drawer Sides
6
The soft close brackets should be
fitted to both of the drawer sides,
using screws as shown.
C
4
5
3
As
Door Hinges
8
Handle Fixing
From the rear face of the Door, drill
through the holes using a 2.5mm
diameter drill.
From the front face of the Door,
open out the 2.5mm diameter holes
using a 5mm drill.
Screw Handles to Doors with the
Screws provided.
Insert the Hinges into the large
holes in the Doors and secure into
place using Screws .
Stick the Door Buffers onto
the bottom corners of the Doors
opposite to the Hinges.
before fitting the Hinges to your door you will have to drill the hole(s) required
through the appropriate pilot holes for the Handles you have purchased.
PILOT
HOLES
Q
Q
Q
s
s
s
s
C
Q
Fit the Hinge Covers
over the Hinges.
k
Push hook on the Hinge Arm underneath the Hinge Plate.
Press front of Hinge Arm down onto Hinge Plate until it
‘clicks’ into place.
Before adjusting the Doors, use a spirit level to
check the Base (or Top) of the unit is level front-to-
back and side-to-side in the three positions shown.
Height: Loosen screws ‘A’ on fixing
plates and move Door up or down as
required. Retighten screws ‘A’.
A
A
B
C
CLICK!
A
A
B
C
CLICK!
make the unit level beFORe making any adjustment to
the hinges as shown.
Forward or backwards: Loosen
screw ‘B’ on fixing plate and move
Door in or out as required. Retighten
screw ‘B’.
sideways: To move Door ‘OUT’ at
hinge position, slacken screw ‘C’.
To move Door ‘IN’ at hinge position,
tighten screw ‘C’.
A
A
B
C
CLICK!
A
A
B
C
CLICK!
A
A
B
C
CLICK!
k
s
CSS1354 02/10*
