PW-100
V5
PW-100
V5
2
3
COMPONENTS AND RECOMMENDED LOCATIONS IN THE VEHICLE
(1) Electronic unit
(1) Digital keyboard & internal microphone
(1) 100W loudspeaker
(2) External microphones
(1) Internal speaker
(1) Keyboard harness
(1) Power cable (battery)
(1) Fuse 15A
(1) Speaker extension cables
(1) Loudspeaker and auxiliary load harness
DIGITAL KEYBOARD
& INTERNAL MIC
ELECTRONIC UNIT
PW-100
EXTERNAL MIC
EXTERNAL MIC
INTERNAL SPEAKER
100W
LOUDSPEAKER
INSTALLATION AND ELECTRIC DIAGRAM
To install the equipment, see the wiring diagram shown further on.
Avoid leaving visible cables in the cabin to leave the vehicle’s aesthetics unaffected.
If there are any cables left disconnected, insulate them with tape; disconnected cables
making an undesired contact can cause a malfunction.
Electronic Unit
Place it on a hidden location for aesthetic purposes. Make sure that the
location allows some ventilation into the unit to avoid overheating.
Digital Keyboard
To facilitate the handling of the equipment, place the keyboard on a location
within the driver’s reach, such as the console of the vehicle. To ensure an
adequate adherence, clean the surface where the keyboard is to be sticked.
Remove the protective liner from the adhesive pad in the back side and stick
it to the surface.
To clean the keyboard, gently wipe it with a dry cloth. Do not use water or any
solvent.
Loudspeaker
When selecting the location for the loudspeaker, keep in mind that
this component is weather resistant but it is not immersion-proof. The
loudspeaker must be placed as far as possible from the keyboard (where the
internal microphone is) to prevent feedback.
Splice and tape the loudspeaker wires to the output wires (they have no
polarity).
External Microphones
Two locations are recommended for installation, as explained on the next
page.
Internal Speaker
Place the speaker out of view, without affecting the sound.
EXTERNAL MICROPHONES INSTALLATION INSTRUCTIONS
Each microphone includes a shell to hold it
in place and protect it from the elements.
Depending on the installation procedure, it can
be more convenient to assemble microphone
and shell either before or after the wiring.
For instance, if the wiring requires to pull
the cable through a narrow space, it is
recommended to assemble after wiring.
Micr shell assembly procedure
1.
Insert the cable in the shell by pressing it with your finger.
2. Push the microphone into the shell (do not pull the cable!).
3. Remove the liner from the tape and stick it to the shell.
4. Stick the shell on the selected surface, previously cleaned
with alcohol.
Recommended locations to install the microphones
There are two recommended locations in the vehicle
(see figure to the left), they differ with regard to ease
of installation and audio reception volume.
You can select a location according to your
preferences.
Location A
Inside the rearview mirror.
This location offers the highest
volume yet the most time
consuming installation, as it
requires to take parts of the
vehicle apart.
Location B*
In the gap of the front doors.
Select a surface to place the
microphone, so that it faces to
the exterior from inside the gap.
Once the surface is selected,
the installation is fairly easy.
* WARNING!
On
location B,
place the
microphone slightly
downward to prevent
damage from water
clogging.
Shell
Microphone
Mounting
tape
