BANDELIN Sonorex Super 510, Инструкция пользователя

Страница: 14 / 36

Sonication fl uid
Insert basket
Contact
fl uid
Sonication fl uid
Inset beaker
14 / 36 1556g GB/2019-02
1 electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
4 Use
Direct sonication
Normally, sonication takes place directly in the oscillating tank. For this
purpose, the objects to be treated are placed in a basket and hung inside the
oscillating tank which is
fi lled with sonication fl uid.
Indirect sonication
Indirect
sonication in inset beakers is to be conducted for special applications or to protect the
stainless steel oscillating tank in the case of:
- Sonication of sample
fl uids.
- Use of chemically aggressive fl uids (e.g. using acids as cleaning agents).
- Removal of chemically aggressive soiling (e.g. cleaning of developing
machine racks).
- Removal of abrasive contamination (e.g. polishing pastes, quartz, sand).
For indirect sonication, a contact liquid (water + surfactants) must be
fi lled in
between the inset beaker and the oscillating tank.
4.1 Instructions for use
Instructions - fi lling
• For ultrasonic baths with outlet, verify that the ball valve is closed.
• Ultrasound and heating must be turned off.
• Do not
fi ll ultrasonic tank with hot water. Maximum fi lling temperature: 50 °C.
• At least drinking-quality water must be used to fi ll the oscillating tank.
• Water without additives is not suited for sonication. BANDELIN recommends the TICKOPUR or
STAMMOPUR preparations.
• Only use distilled or deionised water without additives in inset beakers or insert tubs.
• The
fi ll level must always be at or slightly above the fi lling level mark.
A low fi ll level will damage the ultrasonic bath!
• Do not use any combustible, explosive, non-aqueous liquids or azeotropic mixtures directly in
the stainless steel oscillating tank (e.g. benzine, solvents). Furthermore, chemicals that contain
or that separate chloride ions (some disinfectants, household cleaners, and dish detergents),
may not be used directly in the stainless steel tank.
• When working with aggressive preparations in inset beakers or insert tubs: Prevent the contact
liquid or stainless steel surfaces from being sprayed. If necessary, replace the contact liquid,
clean the surfaces and wipe dry.
• When using strongly acidic preparations, the hard chromium plating of the ball valve may
become corroded and the ball valve start to leak.
If the use of a strongly acidic cleaning agent cannot be avoided, the use of a stainless steel ball
valve is recommended.
• When using preparations, the safety instructions included in the product lea fl ets are to be
fundamentally adhered to.
• Replace used sonication fl uids, do not refresh by adding fl uids.