PART NO: MS0104. REVISION 1 - MAY 2017
prior to installation
preparation - pull tab
a. prior to installation of the Auto-Lock, pull to remove
the battery isolation tab.
b. Once removed the battery will engage and the
lock is operational.
Examine the garage and proceed to either standard
installation on either L/h or R/h side of door.
standard installation
preparation - mounting on door stile
a. Fit the mounting plate
(2)
to the garage door lock
(1)
using two button head screw zN M6 x 14 screws
(13)
.
b. Close the door to determine mounting position
between the reinforcing braces on the bottom
door panel and mark. Fit the lock and lock plate
assembly as marked with 2 only of the 4 tek screws
14g-20x25 flng hD CL4 to the inner two slots only as
the outer two slots are covered by the tracklock
and further final adjustment may be required.
c. with the door in the closed position align the lock
strike
(3)
with the lock allowing for vertical and
horizontal movement of the door drill 2 x ¼ holes
as marked in the tracklock and fix with 2 x 6mm -
20-Tpi uNC x 1/2 sQ neck bolts and nuts.
d. Open and close the door, operate the lock
manually make sure the lock bolt fully engages in
the strike bracket without catching and
adjust as
required before fitting the remaining tek screws to
the lock base plate and ensuring the three strike
nuts and bolts are tight.
PROCEEd TO CONNECTING WIRELESS BASE STATION TO
THE OPENER.
(13)
(1)
(2)
2
Auto-Lock Kit - Panelift
®
Storm-Shield
™
installation instructions
