Diamond PD Power Drive : Instruction
Manual
11
Controll-A-Door
®
S SDO-3
Home Owner’s Manual
© Copyright 2012 B&D Doors
Press DOOR
CODE button
three times
Select one of the
four buttons (not
programmed yet )
you wish to use to
control the Vacation
Mode
8.3 Setting the Transmitter to Operate
Vacation Mode
The opener can be programmed into a “Vacation
Mode” where the opener will not respond to any
transmitter except one preprogrammed unit.
a. Press DOOR CODE button three times. The
DOOR CODE LED will illuminate and the courtesy
light will flash slowly (once every two seconds) to
indicate Vacation learning mode is active.
(Fig.
8.3)
b. Choose a transmitter button not already coded
into the receiver. Press this button and the DOOR
CODE LED will begin to flash.
c. Press the same transmitter button again. The
DOOR CODE LED will illuminate for one second
and then go out, and the courtesy light will also
switch off. This indicates the code has been stored
(Fig. 8.3)
.
d. To activate Vacation Mode, close the garage
door and press the coded button transmitter for
5 seconds. The DOOR CODE LED will illuminate
to indicate that the opener is in Vacation Mode.
e. To exit Vacation Mode press the transmitter button
momentarily until the DOOR CODE LED turns off.
8.4 To Erase Programmed Codes
If the DOOR CODE button is pressed and held for 6
seconds the DOOR CODE LED will blink rapidly for
one second to indicate that all programmed codes
have been erased.
(Fig. 8.4)
8.5 Installation of the Wall Mounted
Transmitter
a. Mount the transmitter in a convenient location,
yet out of reach of children and at least 1.5m off
the ground
(Fig. 8.5)
.
b. Make sure the door is visible from this location.
c. To set the transmitter codes refer to 8.1.
8. Coding Transmitters
Fig. 8.3
Fig. 8.4
LED
Button
Fig. 8.5
