10
*1 Where a mobile emergency system (e.g. comtac 1204) is connected, an emergency call will be trans-
mitted to the emergency call centre after a warning alarm period. If this message shall not be sent, the
emergency call must be cancelled within the acoustic pre-alarm period (see Sec. 3.2.6).
2.3.1 Function check
Warning!
Risk of accident due to other winch controls.
If there are two separate connectors for the manual control and the radio remote control on your skid-
der, only one control system may be connected at any one time!
Thus ensure that the manual control cable is disconnected first before starting to operate the remote
control system.
Before starting the following function check must be carried out
Correct wiring on the vehicle side and to the winch socket and the correct assignment of the plug
on the receiver connection cable
Check that the transmitter battery is fully charged
First switch on the 12 V power supply to the receiver, then operate the transmitter.
For safety reasons, the receiver blocks all commands if commands are already being send by the transmitter
when the receiver is switched on. If this occurs, briefly switch the transmitter off and then on again. Now the
system can be operated.
We recommend that you always perform the following checks before operating the equipment!
Warning!
Risk of accident due to faulty system.
It is strictly forbidden to continue working if the system is faulty.
Return the whole system – transmitter, receiver and connection cable – for repair, suitably packaged
and including a completely filled out Delivery Note with a precise description of the fault, to the
address shown on the second to last page.
The Delivery Note form can be downloaded from the website: www.funk-im-forst.de
