p/n 8450R001 EIR205 3409qsg-2/2
© 2009 by B&B Electronics. All rights reserved
International Headquarters:
815-433-5100
www.bb-elec.com
European Headquarters:
+353 91 792444
www.bb-europe.com
B
&
B
E
LE
C
T
R
O
N
IC
S
QUICK START G
U
IDE
Fiber Optic Cable Information
Mode and Distance
Type
Wavelength
Multi-mode (2 km)
62.5/125 µm
1310 nm
Single-mode (15 km)
9/125 µm
1310 nm
Single-mode (40 km)
9/125 µm
1310 nm
Single-mode (80 km)
9/125 µm
1550 nm
Output Power
RCVR Sensitivity
Multi-mode (2 km)
-19 to -14 dBm
≤
-32 dBm
Single-mode (15 km)
-15 to -8 dBm
≤
-32 dBm
Single-mode (40 km)
-5 to 0 dBm
≤
-34 dBm
Single-mode (80 km)
-5 to 0 dBm
≤
-34 dBm
MDI Cable Pinout
Pin Signal
1 Tx+
2 Tx-
3 Rx+
6 Rx-
MDI-X Cable Pinout
Pin Signal
1 Rx+
2 Rx-
3 Tx+
6 Tx-
Attach RJ45 Cable
1. Auto MDI/MDI-x is
supported. A straight
through or cross-over
cable may be used.
2. 10/100BaseT auto
negotiation and full/half-
duplex are supported.
Attach Fiber Optic Cable
(if equipped)
1. Slider
Guide
2. Slider
Ridges
3. Slider
1.
Ensure your fiber optic cable is terminated with
the correct connector type. EIR205 switches use
SC or ST connectors.
2.
Fiber optic type for each port is located on the
product’s side label. When connecting the cable
to the switch, be sure to line up the slider guide
on the cable and switch connectors.
3.
Connect the fiber optic transmitter to the
downstream device’s receiver and vice-versa.
Installation Complete
1. When the network cables are attached and power
is applied, installation is complete.
2. The switch will automatically discover network
devices, populate its MAC address table, and
pass traffic to the appropriate ports.
Female RJ45
Mechanical Diagram
