Installation and Operations Manual
— Model 400 Series
TROUBLESHOOTING
13
B&B ARMR
A Division of B&B Roadway and Security Solutions 04X0 Rev G
2. INSTALLATION
2.1 Introduction
We designed the Model 400 Series vehicle barriers for quick and easy installation. However,
every site is different and each 400 series will vary due to the choice of options or special
design features. Accordingly, the instructions below may have to be varied slightly for your
particular installation. If you need help, or are unclear about any of these instructions, please
contact B&B ARMR for assistance.
Your safety is extremely important to us. Be sure to
follow the specific instructions presented below.
You are responsible for the correct and safe
installation, operation, and maintenance of this
equipment.
2.2 Preliminary Considerations
Before beginning site excavation and barrier installation, note the following important
considerations.
Inspect the site and verify there are no underground utilities or overhead wires or
obstructions in the excavation area.
If possible, locate the installation away from routine foot traffic to reduce the
chance for pedestrian injury from the barrier's moving gate.
Make sure that there is adequate free area adjacent to the motor stanchion's
installation location so that the vehicle barrier gate can be slid onto the stanchion
after the stanchion is cemented in place.
Locate the HPU within twenty feet of the wheel stanchion. If the pump needs to
be further away from the stanchion, please contact B&B ARMR.