Bancolini Nylux, Руководство пользователя

Страница: 30 / 32

APPENDIX D Guidelines for correct battery use
•
The terminal recharge area must be kept free from inflammable or chemical
•
materials and particles. Special care must be taken when the terminal is charged in an non-
commercial environment.
•
Do not use non-original batteries and/or power supply units and battery chargers. Please contact
customer services at Bancolini for any enquires regarding the compatibility of batteries, battery
chargers and power supply units.
•
Do not crush, puncture or apply excessive pressure on the battery.
•
Violent impacts due to battery-powered devices falling on hard surfaces can cause the actual battery
to overheat.
•
Do not leave or store the device in or near areas that can reach high temperatures, such as inside
parked cars or next to a radiator or any other source of heat. Do not put the battery in ovens or
driers.
•
Do not throw the battery in a fire
•
If you think your device or battery is damaged, call Bancolini customer services to organize a general
inspection.
APPENDIX E Safety provisions for class II laser use
Protective Housing Statements
CAUTION - CLASS 2 LASER LIGHT WHEN OPEN, DO NOT STARE INTO THE BEAM.
ATTENTION – LUMIERE LASER EN CAS D'OUVERTURE. NE PAS REGARDER DANS LE FAISCEAU.
VORSICHT – LASERLICHT KLASSE 2, WENN ABDECKUNG GEOFFNET. NICHT IN DEN STRAHL BLICKEN.
Required Location
For most end products, this text should be located on the exterior of the product, or inside the battery
compartment, software module compartment or other user accessible area.
Access to these areas must not require special tools. Refer to the current applicable laser safety standards for
the end product for specific requirements for the end product.
Font
Use a sans serif type font such as Arial or equivalent. The height must be at least 0.032 in. minimum.
Color
No color requirement. Contrast must be hight enough to render this text legible.
Laser Safety Statement
The Symbol SE950 and SE955 scan engines offer integrators a significant advantage in both reduced time to
market and simplified regulatory testing and approvals. The engines contain a full suite of host independent
fault protection mechanisms and have been proven to stay within classification during operation and single
fault conditions as required by EN/IEC 60950.* Because this testing was performed by an independent
accredited laboratory, integrators placing the engine in most ITE ( Information Technology Equipment)
products should not need to undergo the significant single-point failure testing that would normally be
required for laser safety compliance (certain types of products aimed at medical, military, or other specialty
markets may require additional testing). Additionally, the scan engines do not require any beam attenuation
(via scanning window attenuation, distance-based attenuation, or other electronic controls) to meet their laser
power classification, provided that the product's laser classification matches the engine.
Motorola will also provide you with the documentation you need to speed through your regulatory approvals.
We will provide:
•
Initial EN/IEC 60825-1 certificates showing classification and restrictions to aid development efforts
30