Screw the plastic feet (S)
to the underside of the
base frame (P).
Put the base frame in the
desired (final) position,and
adjust the feet until the
frame is flat and level,
before placing the base
weights
1.
2.
The next step will require 2
people, because of the weight
of the bases.
Place the base weights (O) in
the base frame (P).
The cutout handles must go
from front to back.
Back
Front
3.
Fix rotation mechanism (A)
to to the base using the
M10 bolts (C).
4.
Place the metal sleeve (E)
over the rotation mechanism (A)
with the square (open) end
upwards.
Line up the corners of the sleeve
with the locators on the round
plastic base plate.
The four dome nipples must sit
inside each corner.
5.
Fix the cleat (H) to the back of the
upright pole (L) using 2 screws (Q).
The looped part goes to the angled
end of the post (top).
6.
Steps
6.
and
7.
require
a PH-2 screwdriver.
(Not supplied)
Instructions for
attaching the winch
are on page 2.
7.
9.
Attach the end hook (G) to the
end of the cross-pole (M) with
bolt(R) and plastic step washers.
Note the direction of the hook.
8.
Bolt the metal elbow (F)
to the top of post (L)
Make sure the pulley
points upwards.
Using a suitable ladder,
insert the angled end
of cross pole (M) into
the metal elbow (F)
and secure with
bolt (R) and plastic step
washers.
The cut-out faces up.
10.
Place the top bolt (J)
through the hole in the
metal tube on the parasol
canopy (N).
(This may already be
done.)
Using 2 people and a step
ladder, hook the canopy
bolt into the cutout in
bracket (G).
Then put the larger (grey)
plastic step washers and
M10 self locking nut on
either side.
Make sure the stepped washer
sits in the circular part of the
cut-out.
See diagram.
Then tighten the nuts using the
spanners provided.
11.
Carefully place it into the
metal sleeve (E).
Make sure it is fully down.
Secure the post with
bolt (R), and the clear
plastic stepped-washers.
LEVANTE SIDE WIND INSTUCTIONS.
