baltur TBML 80 ME, Инструкция по установке, использованию и обслуживанию

Страница: 93 / 124

ENGLISH
31 / 60
0006160032_201711
NATURAL GAS IGNITION AND REGULATION
• Bleed out the air contained in the gas piping, with due precautions
and with doors and windows open.
• Open the union on the pipe near the burner and then open the
shut-off valves a little.
Wait until you smell gas, and then close the valve.
• Wait the time necessary for the gas in the room to disperse outside.
Re-connect the burner to the gas pipeline.
• Check that there is water in the boiler and that the gate valves of
the system are open.
• Check that the discharge of combustion products through the boiler
gate and flue gate take places freely.
• Check that thee voltage on the mains meets the manufacturer
requirements and that all electrical connections made at the
installation site are performed properly as illustrated in our wiring
diagram.
• Make sure that the combustion head is long enough to enter the
furnace following the measure specified by the boiler manufacturer.
• Check that the air regulation device on the combustion head is in
the correct position to deliver the required fuel.
• The air passage between disk and combustion head must be
considerably reduced with minimum fuel delivery.
• Increase combustion air flow when fuel delivery increases.
• Refer to chapter "Air adjustment on the combustion head".
• Fit a pressure gauge of appropriate scale to the pressure intake
on the gas pressure switch (if the amount of pressure to be used
allows it, we recommend to use a water column instrument; do not
use instruments with indicator pointers for low pressures).
1
2
10 3
4 9
11 5
display_TBML_ME
1 ON / OFF main switch.
2 Thermostatic line switch
3 Display
4 Unlock or RESET button
5 Fuse.
9 Fuel fill button
10 Fuel selector switch
11 Programming keypad