baltur TBML 80 ME, Инструкция по установке, использованию и обслуживанию

Страница: 76 / 112

If the program is interrupted (due to a power supply failure, manual
action or the intervention of the thermostat, etc.) during the pre-wash
stage, the programmer returns to its starting position and will automati-
cally repeat the whole of the burner ignition sequence.
CAUTION / WARNINGS
The selection of the nozzles in function of the desired total flow
rate (2 nozzles in operation) must be made accounting for the
flow rate values that correspond to the diesel operating pressure
of 12 bar. Replacing the nozzles it is possible to change consi -
derably the ratio between first and second stage.
OPERATING DESCRIPTION TBML 210 - 310 ..
The burner's hydraulic circuit is equipped with a solenoid valve and a
by-pass adjusting valve for a smooth vibration-less ignition when ope -
rating with liquid fuel.
A part of diesel is thus drained only during the first 3-4 seconds of ope -
ration of the burner. Once ignition is complete, the by-pass solenoid
valve closes and the rate corresponds to the first stage value.
Use a screwdriver on the by-pass adjusting screw located inside the
cap (16), (screw in to increase the pressure) so as to obtain only du -
ring the ignition stage a pressure of approx. 9 bars, measured by con -
necting a pressure gauge in position (17).
Correct if necessary the corresponding amount of combustion air by
acting on the electronic equipment settings.
1
2
10 3
4 9
11 5
display_TBML_ME
1 ON / OFF main switch
2 Thermostatic line switch
3 Display
4 Unlock or RESET button
5 Fusibile.
9 Fuel loading button
10 Fuel selector switch
11 Programming keyboard
0002570210funz
TBML 210, 310,
17
16
16 Cap for by-pass adjusting screw
17 Pump pressure gauge connection.
ENGLISH
20 / 54
0006160337_202006