Baltech TL-0208C, Руководство по эксплуатации

Страница: 11 / 20

To select an operation mode and set up parameters of the
device, use the button «MODE». The selection of the
required mode is performed by multiple pressing of a button
and through control of the required mode on the device
display. The device operation modes and sequence of their
selection are shown on the figure 3.4. After the mode is
selected, press the measurement start button and start
measuring. Release the button to switch off the device. The
device will switch off in about 6 seconds.
3.3.2 Operation modes of the device
Operation mode
Parameter Setup
Figure 3.4
1. Scanning and displaying
temperature during
measurement
2. Maximum temperature
during measurement
3. Minimum temperature
during measurement
4. Average temperature
during measurement
5. The difference between
the maximum and the
minimum temperature
during measurement
6. Recalling the stored
measurement results by
using
or buttons.
7. Setting of a controlled
surface emissivity
8. Setting of the highest
alarm temperature
9. Setting of the lowest
alarm temperature
(The parameters are set
with
▼
or
▲
buttons)