D-CH-1
Assembly Diagram
Note: It is recommended that when attaching stability panels, loosely tighten until all
four screws and thread posts are positioned before fully tightening with Allen Wrench.
Illustration # 2 - Leg Assembly
4. Attach Stability Panel / Cable
Tray (P2) and Bottom Stability
Panel (P7) to Leg Frame (P1)
and Leg Frame for CPU (P1A)
using 6 Flat Head screws (A)
and 6 Interior Threaded Posts (B)
as shown in illustration # 2.
{Make sure Large holes on the Bottom
Stability Panel (P7) match with the
Large holes on the Leg Frame (P1A)}.
See Detail # 2-A for CPU Assembly
5. Attach Lower Platform (P6) to
Leg Frames (P1) using 4 Flat
Head screws (A).
6. Attach 4 Leveling feet (C) or
Casters to Leg Frames
[If casters, 2 Locking casters
(D) in the front and 2 Casters
(E) in the back.] Tighten the
Casters using Caster Wrench (G).
Detail # 2-A
Q
N
P
N
Q
P10
7. Attach 2 CPU Rods (P10) to
Leg Frame (P1A) as
shown in Detail #2-A.
8. Secure each Rod with 2 Hex Nuts
(Q), 2 Flat Washers (N), and
1 Black Plastic Spacer (P).
P1A
A
P1
D
E
P6
P7
P2
A
B
Large Holes for CPU Holder
See Detail 2-A
P1A
* Above illustration shows P1A as the Left Leg Frame, for the CPU
Holder to be on the Left side of the unit. If CPU Holder needs to be on
the Right side of the unit, Asemble P1A frame as the Right side Leg
Frame.
