4
Attach Cord Winder (P-8) and Electrical
Strip (P-9) to Top Shelf (P-2), or Base
Cabinet (P-1) using 2 screws (
E-1
) and
2 Hex Nuts M5 w/Flange (
E-2
).
Tighten all screws using
Phillip’s head screwdriver and
Wrench (Not Provided).
Remove Screws (A-3) from bottom of Left and
Right Support Tubes (P-4 & P-5). Insert the
tubes into the Top Shelf (P-2) and attach with the
two Screws (A-3) removed earlier as shown in
Illustration # 3.
Illustration # 4
Illustration # 3
The Balt product you have purchased is guaranteed against material and workmanship defects. This guarantee
extends 1 year from date of purchase. Should this product fail to function satisfactorily under normal use due to
defect or imperfection, the defective part or product will be replaced. Damage caused by common carriers during
shipment is not included in this guarantee.
This guarantee sets forth all applicable guarantees and remedies. No other warranty, expressed or
implied shall apply. Failure to follow instructions found in Important Information Section of Owner Sheet
shall void the guarantee. Consequential or incidental damages and or costs are not refundable.
Important
P-9
P-2
P-8
P-4
P-5
A-3
P-2
A-5
A-4
P-6
P-7
P-4
P-5
4.)
5.)
6.)
7.)
8.)
P-2
Loosen installed Screws
A-4 and A-5 from LCD
Brackets P-6 and P-7.
Attach Bottom LCD
Bracket (P-7) to Left and
Right Support Tubes
(P-4 & P-5) at desired
height using 2 Screws (A-5).
A-4 and A-5
Screws come
preinstalled in
P-6 and P-7
Brackets.
Screws A-3
come preinstalled
in P-4 and P-5
Tubes
E-1
E-1
E-1
E-1
E-1
E-1
E-1
E-1
E-1
E-1
E-2
E-2
E-2
E-2
E-2
Attach Top LCD Bracket
(P-6) to Left and Right
Support Tubes (P-4 & P-5)
at desired height using 2
Screws (A-4) as shown in
Illustration # 4.
