3
Measure the length and width of your new board. Determine the wall center line and height
off the floor that you want your new board to be located. Hold your board up in position and
draw a line under the bottom of the board and parallel with the floor. If your wall has studs,
determine the centerline of the studs. It is recommended that you tie into as many studs
as possible when mounting your board. .
aring to Install
Preparing to Install Your New Glass Board
NOTE: The proper installation of your board will require at least two people.
Tools required: Tape measure, chalkline, electric drill / screwdriver, drill and
screwdriver bits, stud finder and level. .
1.)
Illustration # 1
2.) Measure 1” up from your line and draw a second parallel line. You will need to drill 3/16”
diameter holes in the back leg of the Tray extrusion for your mounting Screws (D). See
Detail #2A for location. Follow the recommended hole locations, correct wall mount
anchors and correct predrill for your type wall from Page 2. Attach Tray (P2) to the
wall using the correct mounting hardware for your type wall. .
Illustration # 2
1”
Bottom of
Board Line
P2
D
Detail #2A
Drill 3/16” diameter screw
holes on this line
1”
