Balluff BVS HS-QB-SDR-MA-02-02, Руководство по эксплуатации

Страница: 21 / 296

21
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
3
Setup
3 Setup
3.1 Unpacking Check carefully to ensure the reader and any accessories ordered are present and undamaged. If
any damage occurred during shipment, contact our Technical Support. Information is shown on
page 16 .
KEEP THE PACKAGING. Should the unit ever require service, it should be returned in its original
shipping container.
3.2 Setting Up the
Reader Depending on whether you are using a Corded or Wireless version of the BVS HS Q - Series of
readers, follow the steps provided in this section to connect and get your reader up and commu-
nicating with its host.
1 Begin by Installing the Interface Cable (Corded) or Connecting the Base Station.
2 Go to Interface Selection and set the desired interface.
3 Configure Interface Settings (only if not using factory settings for that interface).
4 Go to Configuring Other Features (if modifications are needed from factory settings).
3.3 Installing the
Interface Cable For Corded versions, connect the reader cable by inserting the cable into the handle as shown in
Figure: Connect/disconnect the cable . To remove it, insert a paper clip into the release aperture,
then unplug the cable.
Figure 1: Connect/disconnect the cable
Figure 2: RS-232 Serial Connection
Turn off power to the terminal/PC and connect the reader to the terminal/PC serial port via the
RS-232 cable as shown in
Figure: RS-232 Connection . If the terminal will not support POT
(Power Off the Terminal) to supply reader power, use the approved power supply (AC Adapter).
Plug the AC Adapter barrel connector into the socket on the RS-232 cable connector and the AC
Adapter plug into a standard power outlet.