Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 112 / 296

112
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Code 39 Set Length 1
This feature specifies one of the barcode lengths for Code 39 Length Control on page 111 .
Length 1 is the minimum label length if in Variable Length: For variable length decoding, a mini-
mum and maximum length may be set. on page 111 Mode, or the first fixed length if in Fixed
Length: For fixed length decoding, two different lengths may be set. on page 111 Mode. Length
includes the barcode’s data characters only. The length can be set from 0 to 50 characters.
Table Code 39 Length 1 Setting Examples provides examples for setting Length 1. See page 232
for detailed instructions on setting this feature.
Code 39 Length
1 Setting
Examples
STEP ACTION EXAMPLES
1 Desired Setting 00 Characters 07 Characters 15 Characters 50 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 39 LENGTH 1 SETTING
4
Scan Two
Characters
From
Appendix
18, Use the
barcodes in this
appendix to
enter numbers
as you would
select digits/
characters from
a keypad.
‘0’ and ‘0’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Code 39 Set Length 1 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CC3L1
~
DEFAULT
02 = Length 1 is 2 Characters