Optoelectronic Sensors
Laser Distance Sensor BOD 63M-LI06-S4 with IO-Link
5
Product Part Number
BOD 63M-LI06-S4
Safety Advisory
Laser Protection Regulations
The emitter corresponds to Laser Class 2
according to IEC 60825-1. This means that no
additional precautions need to be taken for
operation. The device should be installed so that the laser
warning label is easily visible.
These devices may not be used in applications where the
safety of persons depends on device function.
The CE Mark verifies that our products meet the
requirements of the current EMC Directive.
Testing in our EMC Laboratory, which is accredited by
DATech for Testing of Electromagnetic Compatibility, has
shown that these Balluff products satisfy the EMC
requirements of the following Generic Standards:
EN 61 000-6-4 (Emission) and
EN 61 000-6-2 (Noise Immunity)
Application
Only for NFPA 79 applications (machines with a supply
voltage of maximum 600 volts). Device shall be connected
only by using any R/C (CYJV2) cord, having suitable ratings.
Principle of operation
The BOD 63M measures distances which are output over
the IO-Link interface. The sensor also has one adjustable
switching output.
The BOD 63M works according to the principle of time of
flight. A light pulse is sent out, reflected from the object
and received again. The time of flight of this light pulse is
measured and converted into a digital distance signal.
Display and operating elements
1) Stability indicator (red)
2) Output function indicator
OUT 2 (yellow)
3) Output function indicator
OUT 1 (yellow)
4) Power on indicator
(green)
5) SET-button for switching
distance 1 (OUT1)
6) SET-button for switching
distance 2 (OUT2)
Fig. 1: Display and operating elements
The
green LED
indicates the ready state of the sensor.
The
yellow LED
“OUT 1” indicates the „active“ state of
switching output 1.
The
yellow LED
“OUT 2” indicates the „active“ state of
switching output 2.
The
red LED
indicates that the intensity of the signal for
reliable operation is not sufficient.
The
SET
buttons are used to set the switching distances
of the sensor independently of each other.
Installation
1) Optical axis of emitter
2) Optical axis of receiver
3) Display and control panel
4) rotatable by 270°
Fig. 5: Dimensions
Connections
Fig. 2: Wiring diagram, connector pins
