2
Connect the Distributed Modular I/O Master Block
1
1. Using an M12 D-coded EtherNet/IP cable, connect the block to the Ethernet network.
2. Power up the block using 24VDC and a 7/8" 4pole connector wired according to the below diagram.
3. Set the IP address of the block using the pushbutton display. For instructions on operating the display, see the manual.
Port 0
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
IO-Link 1
IO-Link 2
IO-Link 3
IO-Link 4
Pin Function
Description
1
TX +
Transmit Data +
2
RX +
Receive Data +
3
TX -
Transmit Data -
4
RX -
Receive Data -
M12 Network Port
Pin Function
Description
1
+ 24 V
Actuator Supply
2
+ 24 V
Sensor/Bus Communication Supply
3
0 V
Sensor/Bus Communication Supply
4
0 V
Actuator Supply
7/8" Auxiliary Power Port
Pin Configurable Port
IO-Link Port
1
+ 24 V
+ 24 V
2
Input 2 or Output 2
Input/Output 2
3
0 V
0 V
4
Input 1 or Output 1
IO-Link or Input/Output 1
5
FE
FE
M12 I/O Port
Network
Aux Power
Pushbutton Display
IP address subnet mask
gateway
00
01
04
15
14
13
12
11
10
09
06
07
08
05
03
02