User's Guide
Inductive Analog Sensor BAW M18MI2-UAC50B-BP05-002/004
Nr. 818914 DE/EN Edition B16
3
BAW M18MI2-UAC50B-BP05-002/004
Savety Advisory
This analog sensor is not intended for use
where personal safety depends on proper
device function (not a safety component
per the EU Machine Directive). Read the
user's guide carefully before startup.
Function
Inductive, analog sensor including three additional
switching outputs.
The switching distance is programmable.
Dimensions
Connections
Typ -002
Typ -004
Fig. 1: Connection diagram
Balluff GmbH
Schurwaldstraße 9
73765 Neuhausen a.d.F.
Deutschland
Tel. +49 7158 173-0
Fax +49 7158 5010
[email protected]
www.balluff.de
••••
Analog output voltage (U)
••••
3 switching outputs
••••
Type -002 3x NO
••••
Type -004 3x NC
••••
Switching distance programmable
••••
Flush mount
••••
M18x1
Programming switching outputs in Teach-in
There are two ways to use teach-in programming
a) Connect the sensor to the BES 516-4 programmer. A
programming guide is included with the unit.
b) Connect the Control input (C) through a switch to +.
Follow the programming steps below.
Caution! Check for proper wiring. The load circuits must
not be short circuited so that the sensor can be
programmmed.
1 Install the sensor in the machine.
2 Connect the Control input (C) through a switch to +
(Fig. 1).
3 Turn on programming mode: Hold the button down for
at least 5 seconds.
4 Bring the object to be detected (machine member
etc.) to the desired switching position or to a defined
point (e.g. 4 mm from the sensor) within the sensor's
linearity range (Fig. 2).
5 Save switching distance: Hold the button down for 2-4
seconds. The first LED comes on. When the button is
released the next switching output is automatically
selected. The next LED flashes.
6 Program switching outputs two and three as
described under 4. and 5. above. If no more outputs
are to be programmed, exit programming mode as
follows: Press the button for max. two seconds so that
the 3
rd
output is selected. Pres the button again for 2
seconds to return the sensor to operating mode.
7 After programming is complete make the user-side
electrical connections. In operating mode a fixed
connection between the C input and ground is
recommended.
Check switching points
Move the target object (machine member etc.) towards
the sensor. When a switching point is reached, the
associated LED must come on.
