Balluff BAM PC-TL-020-K Series, Руководство пользователя

Страница: 25 / 106

www.balluff.com 5 english
2.1 Intended use
The BTL7-T…-DEX_-ZA1K together with the connection
housing BAM PC-TL-020-K__/KA__-4 is marked as an
electrical device suitable for use in gas and dust explosion
hazard areas. When installed in a machine or system, the
BTL forms a position measuring system in conjunction with
a controller or evaluation unit and may only be used for this
purpose.
When selecting the electrical equipment, the person
setting up the machine or system is responsible for
assessing its suitability for the planned area of application.
The information in the user’s guide and other applicable
safety regulations and provisions must be observed during
set-up.
The operator of the machine or system must ensure that
the BTL is applied under the permissible operating
conditions in line with the information in this user’s guide
and in compliance with the applicable safety regulations
and provisions.
Unauthorized interventions, non-permissible use, or
application outside the permissible operating conditions
will result in the loss of warranty and liability claims against
the manufacturer.
2.2 Safety measures
The persons setting up and operating the machine or
system must take steps to ensure that a malfunction in the
BTL will not result in hazards to persons or equipment. If
there are any indications of damage or malfunctions, the
BTL must be immediately taken out of operation and
secured against unauthorized use.
Even with correct explosion protection, residual risks
remain that could pose a hazard to persons and systems
when the device is correctly operated or if there are any
fault states.
2.3 Approvals, standards, and conformity
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive as well as the ATEX
Directive. Compliance is confirmed with
the enclosed CE declaration of
conformity.
The BTL7-T…-ZA1K combination with BAM PC-TL-020-…
meets the requirements of the following product standard:
– EN 61326-2-3 (noise immunity and emission)
Emission tests:
– RF emission
EN 55011
Noise immunity tests:
– Static electricity (ESD)
EN 61000-4-2 Severity level 3
– Electromagnetic fields (RFI)
EN 61000-4-3
Severity level 3
– Electrical fast transients (burst)
EN 61000-4-4
Severity level 3
– Surge
EN 61000-4-5 Severity level 2
– Conducted interference
induced by high-frequency fields
EN 61000-4-6
Severity level 3
– Magnetic fields
EN 61000-4-8 Severity level 4
Compliance is proven through the EC type examination
certificate EPS 17 ATEX 1019 X and a CE declaration of
conformity.
The BTL is certified under
certification number
IECEX EPS 17.0008 X. The current
version can be found under
www.iecex.com
The applicable safety regulations and standard
requirements must be observed during selection, set-up,
and operation, such as:
– Requirements for occupational safety
– Requirements for explosion protection
– Electrical installations erection in explosive
atmospheres (DIN EN 60079-14)
– Classification “e”, increased safety
– Special requirements for equipment in device group II,
category 2G
– Special conditions for safe operation (X)
More detailed information on the guidelines,
approvals, and standards is included in the
declaration of conformity.
2
ATEX safety notes
BAM PC-TL-020-K_ _/KA_ _-4
Connection cover for magnetostrictive linear position sensor