Balluff BAM MD-VS-001-0002, Руководство по эксплуатации

Страница: 270 / 314

270
4
References
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Motionless
Timeout Setting
Examples
4.8 Wireless
Features
4.8.1 Automatic
Configuration
Update
When this feature is enabled, the base station and reader will keep their configurations synchro-
nized. If a reader's configuration is altered by reading programming labels, this change is auto-
matically transferred and updated in a linked base station. Likewise, if the base station's
configuration is changed using host commands, then the reader's configuration will automatically
be updated if this feature is enabled.
4.8.2 RF Address
Stamping
Source Radio
Address
Delimiter
Character This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
Follow these instructions to select the delimiter character:
1 Determine the desired character, then find its hexadecimal equivalent on the ASCII Chart on
the inside back cover. A setting of 00 specifies no delimiter character.
2 Go to page 218 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
3 Scan the barcode: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.
4 Scan the appropriate two digits from the keypad in Appendix D: Keypad , that represent the
hexadecimal characters which were determined in the steps above. You will hear a two-beep
indication after the last character.
5 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.
STEP ACTION EXAMPLES
1 Desired Setting 500ms 1 sec. 10 sec
9,900ms
(9.9 sec.)
2
Divide by 100 (and pad
with leading zeroes to
yield two digits)
005 010 100 250
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT MOTIONLESS TIMEOUT SETTING
5
Scan Two Characters
From
Appendix D:
Keypad
‘0’, ‘0’ and
‘5’
‘0’, ‘1’ and
‘0’
‘1’, ‘0’, and
‘0’
‘2’, ‘5’, and ‘0’
6 Scan ENTER/EXIT PROGRAMMING MODE
NOTE
This feature only applies if "Source Radio Address Transmission" on page 218
is enabled.
NOTE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.