Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine location for Oranizer and locate at least two WALL STUDS in wall behind it. Use a
level to position Wall Bracket (D) and center a hole over each WALL STUD. Insert and drive Screw (A)
directly into WALL STUD.
For holes located in open drywall (no stud) use an Expansion Bolt (B).
See Step 2 for installation instructions.
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(D)
(B)
(A)
STEP 2: For Bracket hole locations where no wall stud is present, mark location and use a drill with a
3/8” bit to create a pilot hole. Lightly tap Expansion Bolt (B) into hole and sink teeth into wall surface.
Drywall
3/8” Drill Bit
(B)
Teeth
