Contact us for assistance: (866) 985-7877 | www.
balkenehome.com
4
AssemBlY
1
Locate one
A-Frame
Top
A
and one
Front Frame Leg
B
.
(HINT: the
Front Frame Legs
are slightly longer than the
Back
Frame Legs
.) Place the
A-Frame
Top
flat on the ground with the
90° angle to
the
left. Align the
Front Frame Leg
to the right side
of the
A-Frame
Top
as shown
. (Check orientation by
comparing the drilled holes to the inset drawing below right.)
Connect the pieces by fitting the Joint Bracket
E
over the joint
(matching the holes in the Joint Bracket with the holes in the
two frame pieces where they meet). Insert 2
Female
Screws
L
through the Joint Bracket and into the frame. Insert 2
Male
Screws
K
from the opposite side, as shown. Tighten
each
Male Screw into the corresponding Female Screw
using the
Hex Key
O
.
2
Finish assembling the first A-Frame by connecting the Back
Frame Leg
C
. Align the Back Frame Leg with the A-Frame Top
as shown. (Check orientation by comparing the drilled holes to
the inset drawing below right.)
Connect the pieces by fitting the Joint Bracket
E
over the joint
(matching the holes in the Joint Bracket with the holes in the
two frame pieces where they meet). Insert 2 Screws
L
through the Joint Bracket and into the frame. Insert 2 Screws
K
from the opposite side, as shown. Tighten hardware using the
Hex Key
O
.
A
B
L
K
Hardware Used:
K
Male
Screw (6x10mm) x 2
L
Female
Screw (
8x15
mm) x 2
Hardware Used:
K
Male
Screw (6x10mm) x 2
L
Female S
crew (
8x15
mm) x 2
The left A-Frame is now complete. Assemble the right A-
Frame by following the same steps described above, but be
sure to place the Joint Brackets on the opposite side of the
joints (the Joint Brackets on each A-Frame should face
outwards, AWAY from the shelves supported by the A-
Frames.)
Hardware Used:
K
Male S
crew (6x10mm) x
4
L
Female S
crew (7x48mm) x
4
E
L
K
E
C
PREPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts
are missing, please contact Customer Service before proceeding.
Place all parts on a soft, level surface for assembly. Estimated Assembly Time: 40 Minutes | DO NOT over-tighten
hardware.