Á>UÁ¿É¸¿tµ¿>¸¸¸Á>Ug[¿¿£l½½¤¿lu¼l¼¼¿¿N¿¿ÑÑѦ
L>ggg¦U
¿
6
ASSEMBLY
3
Install the Drawer Runners
?
on the Left and Right Dividers
F
/
G
.
FRONT
BACK
Fully extend the runner to uncover the mounting
holes. After
attaching
the runner
to
the panel, push
runner back into the closed position.
FRONT
BACK
FRONT
BACK
FRONT
BACK
Hardware Required:
1
Cam Bolt x4
?
Runner x2
?
Screw (3x12mm) x6
Fully extend one Runner and align the inner section along the 3 small holes on the Left Divider
F
.
Verify that
the orientation of the Runner matches the diagram, then fasten the Runner to the Divider using 3 Screws
?
positioned as shown. Once the Runner is attached, slide it back to the closed position.
Attach the second Runner to the Right Divider
G
following the same method, checking orientation before
inserting Screws.
Insert Cam Bolts
1
into the
2
indicated holes above the Runners on each Divider.
F
G
1
1
PANEL TOP
PANEL
BOTTOM
PANEL TOP
PANEL
BOTTOM
4
Place Dowels
3
in the
indicated
holes on either side
of the
Center Top
Shelf
H
and Center Bottom Shelf
I
.
Insert the Cam Bolts
1
previously installed in the
Left Divider
F
into the corresponding holes in the
edge of the Bottom Shelf as shown. Secure by
inserting a Cam Nut
2
into each of the adjoining
holes in the underside of the Bottom Shelf. (HINT:
the small arrow on the flat side of the Cam Nut
should point toward the adjoining panel.) Use a
Phillips-head screwdriver to turn the Cam Nuts
clockwise to secure the Cam Bolts.
Attach the Right Divider
G
to the Bottom Shelf
using the same method.
Hardware Required:
2
Cam Nut x4
3
Dowel x
8
2
F
G
I
3
3
H
