Balboa Tranquility ER15 Скачать руководство пользователя страница 16

 

16 

 

ACTS INVALIDATING WARRANTIES 

These warranties shall be null and void if the spa has been subject to alteration, misuse or abuse (or is used in manner that is not consistent with the product specifications or 

for which it is not designed) or if any repairs to the spa are attempted by anyone other than an authorized representative of Emerald.  Alteration shall include but is not lim-

ited to any component or plumbing change, electrical conversion, or the addition of any non-approved sanitation or water purification device or heating system, which 

contributes to a component or unit failure, or unsafe operation of the system.  

CORROSION OR DEGRADATION TO THE SPA SHELL, SURFACE, FIT-

TINGS, STAINLESS  ACCENTS,  ELECTRONICS,  PUMP  AND ALL  OTHER  COMPONENTS  THAT  ARE  CAUSED BY  IMPROPER  USE  OF 

CHEMICALS AND/OR WATER TREATMENT ARE NOT COVERED UNDER THESE WARRANTIES

.  Damages caused by the following are not cov-

ered under these warranties:  transportation or installation by third parties; operation of the spa at water temperatures outside the range of 50 degrees F. to 104 degrees F.; 

dirty, clogged or calcified filter cartridges; a defective support system (a solid, flat, level surface is required); harsh chemicals which are not recommended by the plastic 

manufacturer which come into contact with the spa surface; allowing undissolved spa sanitizing chemicals to come into contact with the spa surface; improper water chem-

istry maintenance; allowing the spa to remain uncovered in direct sunlight; freezing conditions; moving or relocating the spa; failure of an inadequate pad, platform, deck or 

other support structure; improper electrical hook-up or wiring; and acts of God or third parties or other damages caused to the spa which are outside the control of Emerald.  

 

LIMITATIONS OF LIABILITY/EXCLUSIONS 

THESE WARRANTIES DO NOT APPLY TO PARTS WHICH ARE NOT MANUFACTURED BY EMERALD AND SHALL NOT 

APPLY TO ANY ITEMS INSTALLED IN OR ATTACHED TO THE SPA AFTER THE DATE OF MANUFACTURE OR TO OP-

TIONAL PARTS OR SYSTEMS WHICH ARE PURCHASED FOR INCLUSION ON OR IN THE SPA

.  

EMERALD SHALL HAVE 

NO RESPONSIBILITY TO AID IN THE ENFORCEMENT OF ANY WARRANTIES AGAINST MANUFACTURERS OF SUCH 

ITEMS, PARTS, SYSTEMS OR OPTIONS. 

 Optional Parts include, without limitation, ozone generator, all audio systems, and LED lighting.  

Emerald shall not be liable for loss of use of the spa or other incidental or consequential costs, expenses or damages, which include but are not limited 

to, water and/or sewage costs, water damage to surrounding areas, rooms or furnishings, the removal of or reinstallation of a wall, deck or other fixture, 

water leakage, costs of shipping or packaging, applicable taxes, or the payment of any costs or expenses of disassembly, removal, or reinstallation of the 

spa or any part.  Pump shaft seal parts are warranted 2 years (unless otherwise excluded as described above) from initial start up of spa and labor is not 

included on such parts  notwithstanding anything above to the contrary.  The stainless steel escutcheon on the stainless steel jet option, fuses, light bulbs, 

spa pillows, spa cover, cover accessories and o-rings are not covered under these warranties.  Under no circumstances shall Emerald or its representa-

tives be held liable for injury to any person or damage to any property, however arising, even if caused by Emerald or its representatives’ negligence.  

Some states do not allow limitation on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or 

consequential damages, so these limitations or exclusions may not apply to you.  These warranties give you specific legal rights, and you may also have 

other rights, which vary from state to state.  No distributor, salesperson, dealer, retailer, or other representative of Emerald other than its President has the 

authority to alter or change these warranties, which changes must be in writing signed by such President.  The warranties herein shall be in lieu of, and 

not in addition to, any other rights and remedies which might be otherwise available to purchaser.  

 

 

 

 

 

 

 

 

 

 

 

  !

"

#$

%

Содержание Tranquility ER15

















Отзывы: