6 – 16 Keppel Drive, Hallam Victoria 3803 Australia Ph: 61 3 9702 3144
TP600
Quick Reference Guide
REST mode will only allow heating during programmed filter cycles. Since polling does not occur, the temperature display may not show a
current temperature until the heater pump has been running for a minute or two.
Press
, then press
repeatedly until ‘MODE’ appears in the LCD. Toggle between READY and REST by pressing
. Press
or wait for 10 seconds to go back to the Main Screen.
Flip (Invert Display)
TP600 has a dedicated FLIP button, which allows the user to flip the display with a single button-press.
Lock
The control can be restricted to prevent unwanted use or temperature adjustments. Locking the Panel prevents the controller from being
used, but all automatic functions are still active. Locking the Temperature allows jets and other features to be used, but the Set temperature
and other programmed settings cannot be adjusted.
Lock the Temperature
Press
, then press
repeatedly until ‘LOCK’ appears in the LCD. Press
3 times, then press
.
Lock Panel
Press
, then press
repeatedly until ‘LOCK’ appears in the LCD. Press
,
,
,
,
.
Unlock the Temperature and the Panel
Press and hold
button and press
twice. The panel will be unlocked after 3 seconds.
Hold
Hold Mode is used to disable the pumps during functions like cleaning or replacing filters. Hold Mode will last for 1 hour unless the mode
is exited manually. If the spa service requires more than an hour, it is best to simply turn the spa off at the main power supply.
Press
, then press
repeatedly until ‘HOLD’ appears in the LCD. Press
. To terminate the ‘HOLD’, press
twice.
Setting Filter Cycles
The system is factory-programmed with two filter cycles that will run in the evening and morning. The filter time and duration are
programmable. The second filter cycles can be disabled as needed.
Press
, then press
repeatedly until ‘FLTR 1’ appears in the LCD. Press
twice, the start time will show and the hour will
flash. Press
repeatedly to set the hour. Then press
to select the minutes. Press
to set the minutes.
Press the
then
, the ‘FLTR 1’ length in hours will show and the hour will flash. Press
repeatedly to set the hour. Then press
to select the minutes. Press
to set the minutes.
Press
3 times, the ‘FLTR 2’ will appears in the LCD. Press
,
then
, the start time will show and the hour will flash.
Press
repeatedly to set the hour. Then press
to select the minutes. Press
to set the minutes.
Press the
then
, the ‘FLTR 2’ length in hours will show and the hour will flash. Press
repeatedly to set the hour. Then press
to select the minutes. Press
to set the minutes.
Wait for 30 seconds to go back to the Main Screen.
Preferences
Set between °F and °C. Press
then press
until F/C appears. Press
and select the mode of temperature you require °F
or °C.
