ATTACH THE ROPES
5. To attach the ropes, first
engage at least one spring
from the carriage to the
springbar to stabilize the
carriage. Unroll the ropes
and separate them.
6. Clip a cotton loop onto the
end of each rope and hang
the loops on the shoulder
rests. (Figure G.) Thread the other end of each rope through a
pulley and back into the cam cleats on the carriage to adjust
the length. Be sure to go through the chrome eyestraps on both
sides of the cam cleats. Always push the rope firmly down into
the cleats to ensure a good drip.
USING THE EXTENSION STOPPER
To limit the carriage travel, insert the extension stopper into the
desired hole in the top of the frame rail.
INSTALLING THE PLATFORM EXTENDER
To install the Studio Reformer Standing Platform Extender on a
Reformer with an Infinity Footbar, first loosen the two black
plastic knobs beneath the standing platform at the end of the
frame. Adjust the footbar so that it is laying horizontally with the
Reformer frame (Figure H)
Gently lower the tongue of the Standing Platform Extender into
the silver bracket on the inside of the frame. Gently tighten the
black knobs on the outside of the frame. (Figure I).
EASY TO USE PLUNGER LOCKOUT KNOBS
Balanced Body’s Allegro
®
Reformer, and Clinical Reformer
®
and
Studio Reformer
®
with Infinity footbars come with plunger lockout
knobs that make adjusting and moving the Reformer footbar
along the frame much easier.
To use, pull the plunger knob straight out so that the recessed
cross-pin comes out of the slots as shown in Figure H. Then turn
the knob so that the cross-pin rests on the bolt head as shown in
Figure I. Repeat on other side.
With the knobs in the “locked out” position, reposition the footbar
along the frame of your Reformer as desired. Then turn the
knobs so that the cross-pin is once again recessed, firmly locking
the footbar into its new position.
INSTALLING THE JUMPBOARD ON A CLINICAL
REFORMER WITH AN INFINITY FOOTBAR®
To install the jumpboard
(regular or Jumpus Maximus)
on a Reformer with an Infinity
Footbar, first loosen the two
black plastic knobs beneath the
standing platform at the foot
end of the frame.
Adjust the footbar to the 4th
position from the end of the
Reformer. Then adjust the footbar to the second highest vertical
position (Figure L). Next, place the tongue of the jumpboard into
the silver bracket on the inside of the frame. Finally, re-tighten
the black knobs on the outside of the frame.
If you have any questions, please call Balanced Body at
1-800-PILATES (1-800-745-2837) or +1-916-388-2838.
Figure G
Figure H
Figure I
Figure L
Figure J
Figure K
05