Balanced Body Allegro Reformer, Руководство пользователя

Страница: 13 / 49

11
7. Pivot the footbar slightly until the large hole at the bottom
of the footbar aligns with the remaining hole in the trunnion
plate.
8. Slide the shoulder bolt with one washer through the large
footbar hole. Then screw the shoulder bolt into the trunnion
plate as tightly as possible with the large allen wrench. Repeat
on the other side. See Figure E.
INSTALL THE RISERS
9. Remove locking pins from the
frame. Insert the risers through
the holes on the top of the
frame. Turn the risers until the
attached pulleys point straight
down the frame toward the
footbar. See Figure F.
10. Reinsert locking pins until the
metal ring touches the frame.
You may need to jiggle or
slightly lift or rotate the riser
to get the locking pins in all
the way.
ATTACH THE ROPES
11. To attach the ropes, first engage at least one spring from
the carriage to the frame to keep the carriage in the home
position. Unroll the ropes and separate them.
12. The Allegro now comes with Soft Touch Ropes that do not have
the dog-clips to attach the loops. The clip will no longer drag on
or bang into the frame! Follow the images below to install your
loops. See Figure G.
13. Rest the loops over the shoulder rests. Thread the other end of
each rope through a riser pulley and back into the cam cleats
on the carriage to adjust the length. Be sure to go through the
chrome eyestraps on both sides of the cam cleats. Always push
the rope firmly down into the cleats to ensure a good grip.
INSTALL THE TRANSPORT WHEEL BRACKET
14. Remove the 1/4”-20 button head screw and the split washer
attached to the last hole in the frame towards the footend of
the reformer, as shown in Figure H, using the 5/32” Allen key.
Slide the preassembled transport bracket into the channel
in the rail at the foot end of the reformer. Line up the hole in
the transport bracket with the hole in the frame rail. Use the
1/4”-20 button head screw and the split washer to attach the
transport bracket on to the frame using the 5/32” Allen key.
See Figure H for reference. Note: The wheel goes on the inside
of the bracket (towards the frame) when it is mounted.
15. Repeat this for the other side of the reformer.
Figure F
Locking Pin
Figure G
2 1
3 4
Figure H
GEN9054
618-008
GEN9472