INSTALL THE CARRIAGE PULLEY BRACKETS
6. Bolt the two carriage pulley brackets to the underside of the
carriage using the 1/4-20x1-3/4” long flat head screws. Use
(2) 1/4” flat washers under the nuts that go over the slots in
the brackets. Make sure pulleys are facing the head end as in
Figure D. If the bolts do not go into the Nylon part of the nut,
it is okay to remove the washers.
7. Install the shoulder rests back onto the carriage by sliding
them into the slots and away from the carriage pad. Install the
detent pins into the brackets to lock in place.
INSTALL LOWER PULLEYS
8. Install the low support bracket into the inside frame head
end along with the low support bracket, using the (2) button
head screws, (4) flat washers, (2) half moon washers and nuts.
The half moon washers will be sandwiched between the two
brackets. See Figure E.
9. Remove the current risers by pulling the ring on the pins on
the end of the frame. See Figure F.
10. Slide the riser block with post down into the post holes and
reinstall the detent pins with ring on the head end.
See Figure G.
INSTALL ROPE AND LOOPS
11. Place the black loops with pulleys on the shoulder posts. See
Figure H.
12. Thread one end of the rope through both pulleys under the
carriage and pull the ends evenly toward the risers.
See Figure J.
13. Take one end of the rope and thread up through the lowest
pulley on the frame. Continue threading the rope up through
the upper, inner pulley on the riser block and pull toward
the carriage. See Figure K.
Figure D
Figure E
Figure C
Figure H
Figure G
Figure F
Hex Nut
1/4-20 x 3/4
Screw
Half Moon Spacer
Washer
2
