TIME AND CALENDAR SETTING
If the clock does not receive the time signal successfully, you can set the time manually. As soon
as the transmitter is received again, the clock will automatically synchronize with the received
time.
1.
In normal mode, press and hold “TIME SET” key for 2 seconds until the Hour format digit
flashing.
2.
Press “DOWN” / “UP” key to select 12/24 hour format.
3.
Press “TIME SET” key again to step the setting item to next item. And press “DOWN” / “UP”
key to adjust the value of the flashing digit.
4. Do the above operation in this sequence: 12/24 Hr format> Hour > Minute > Year > M&D /
D&M format > Month > Date > Time difference > Language.
Note:
If your local time is different from the RC received time, you can set the desired time zone or time
difference. The available time difference is from -23 hours to +23 hours. After setting the desired
time difference, the clock will show the time that RC received time plus/minus the time difference.
ALARM TIME SETTING
1.
In normal time mode, press and hold “ALARM SET” key for 2 seconds until the Hour digit
flashing.
2.
Press “DOWN” / “UP” key to adjust the value of the flashing digit.
3. Pre
ss “ALARM SET” key again to step the setting value to Minute with the Minute digit
flashing.
4.
Press “DOWN” / “UP” key to adjust the value of the flashing digit.
5.
Press “ALARM SET” key to save and exit the setting.
USING ALARM AND SNOOZE FUNCTION
1. Set the desired alarm time as described in the above section.
2.
Push “ALARM ON/OFF” slide switch to “ON” position to turn on alarm function with the icon
displayed on the LCD.
3. When clock reach the alarm time, alarm sound will start. Where, it can be stopped by
following operation:
a. Auto-stop after one minute alarming if without any operation and it will re-alarm by the next
day.
b. By pressing “SNOOZE” key to enter snooze that the alarm will sound again after 5 minutes
(One minute alarm and 4 minutes snooze).
c. By sliding “ALARM ON/OFF” switch to “OFF” position to turn off the alarm function.
Note:
1. The snooze could be used continuously in 24 hours.
2. During the snooze, the alarm icon will keep flashing.
NIGHTLIGHT FUNCTION
1. Pus
h “Night-light” slide switch to ON position to turn on night-light function, the backlight will
automatically turn on in dim & dark environment detected by the night-light sensor.
2.
Push “Night-light” slide switch to OFF position to turn off night-light function.
Note:
The brightness of nightlight is weaker than normal backlight.
