Receiver. onwards
Remarks :
A flashing radio mast symbol indicates that the DCF signal reception has started.
A continuously displayed radio mast symbol indicates that the DCF was received successfully.
We recommend a minimum distance of 2.5 meters (8.2 Feet) to all sources of interference such as televisions
or computer monitors.
Radio reception is weaker in rooms with concrete walls (e.g. in cellars) and in offices. In extreme cases, place
the system at a window.
As there is less atmospheric interference at night, radio reception is normally possible at this time. A single
synchronization each day is sufficient to keep the time display accurate to one second.
Manual Receive Signal:
To start DCF reception manually, press ”WAVE (B3)” button for 2 seconds, The radio mast symbol “
”
starts
to flash. If reception is successful the radio mast symbol
on the LCD display. If you want to stop DCF
reception , press and hold down “WAVE (B3)” for 2 seconds. If no signal is received within seven minutes,
then the DCF signal search stops ( the radio mast symbol “
”
disappears ) and starts again the next full hour.
DCF Signal Reception and Signal Indicator :
Weak or no DCF signal ( only
icon flashing )
Receiving strong DCF signal (
icon flashing )
Successful Reception (
icon becomes static )
Failed Reception (
icon disappear )
Remark : when your clock is receiving radio controlled time signal , all buttons except the “snooze/ light ” button
do not function.
TO Read MAXIMUM-MINIMUM Indoor/Outdoor Temperature and Humidity:
Press the ” UP/MEM (B2) ” button to show the maximum indoor and outdoor temperature and humidity with
“MAX” icons appearing on the display.
Press the “ (B2)” button again to show the minimum indoor and outdoor temperature and humidity with “MIN”
icons appearing on the display.
IN “MAX/MIN” mode, hold ” ( B2) ” button for 3 seconds to clear the recorder max/min reading.
Press ”
/
(B3) ” button to select indoor/outdoor temperature in Celsius mode or Fahrenheit mode.
Display Outdoor Temperature:
Press ”CHANNEL (B5) ” button to show the 3 channels temperature . The sequence is shown as follow:
If only one sensor is registered, press ” CHANNEL (B5)” button will has no function.
Hold “CHANNEL (B5) ” button for 3 seconds to cancel unused channel manually, It will automatically search
and register a new channel again if a new channel is received ,If there no temperature display in existing
channel ( “--- ---“is displayed on the LCD), hold ” CHANNEL (B5) ” button for 3 seconds to cancel that channel
Press
“CHANNEL”(B5)
Press
“CHANNEL”(B5)
Press
“CHANNEL”(B5)
