(5)
Load the oven with product to be cooked.
(6)
Turn the timer knob to the desired bake time and timer will start counting down.
(7)
When timer reaches zero, a buzzer will sound.
(8)
Turn the Timer knob to '0' position to reset.
(9)
Turn the thermostat knob to the desired hold temperature.
(10)
Remove the product from the oven when done.
D. OPTIONAL STEAM INJECTION-ROTARY CONTROL:
The solenoid valve for steam injection is mounted behind the service panel on the right hand side of the unit.
The electronic timer is preset at the factory. A 1/4" copper tubing is provided on the Solenoid Valve for water
hookup with a compression fitting. After the water hookup is made, make sure that there are no leaks. For
steam injection, press the Steam switch momentarily.
NOTE: Do not use steam injection at temperatures below 275°F (135°C).
E. OVEN COOL DOWN-ROTARY CONTROL:
To cool down the oven to a lower desired temperature, follow the steps detailed below:
(1)
Open the oven doors.
(2)
Turn Selector Switch to 'oven cool down' position. Fan will now operate and cool down the oven.
(3)
When the oven has cooled down to the desired temperature, turn the selector switch to the ‘O’
position. Close oven doors.
7
OVEN INTERIOR:
Clean The Racks And Rack Support Guides:
Open the doors and remove all wire racks and rack support guides. Take them to the sink and thoroughly
clean in warm water with mild detergent or soap. Use a nylon scouring pad or stiff nylon brush.
DO NOT USE STEEL WOOL.
Clean The Stainless Steel Interior:
Baked on splatter, oil, grease or discoloration on the stainless steel inside of the oven may be removed with
stainless steel cleaner, or any other similar cleaning agent.
NEVER
use vinegar or any corrosive cleaner.
Use only cleaners approved for stainless steel.
NEVER
use cleaning solvents with a hydrocarbon base.
NEVER
use a wire brush, steel or abrasive scouring pads, scraper, file or other steel tools.
NOTE: ALWAYS RUB THE STAINLESS STEEL ALONG THE GRAINS.
Clean The Blower Wheel:
To clean the blower wheel, remove and immerse in ammoniated water for 20 to 25 minutes. Then, scrub it
!
!
CAUTION:
Use mild detergent or soap solution for best results. Abrasive cleaners could scratch
the finish of your unit, marring it’s appearance and making it susceptible to dirt accumulation.
DO
NOT
use abrasive cleaners or cleaners/sanitizers containing chlorine, iodine, ammonia or bromine
chemicals as these will deteriorate the stainless steel and glass material and shorten the life of the
unit. Use nylon scouring pads.
DO NOT
use steel wool.
!
!
WARNING:
To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit
breaker or unplug the unit from the power source and allow to cool completely before performing
any maintenance or cleaning.
!
WARNING:
Unit is not waterproof. To avoid electrical shock or personal injury,
DO NOT
submerge
in water.
DO NOT
operate if it has been submerged in water.
DO NOT
clean the unit with a water jet.
DO NOT
steam clean or use excessive water on the unit.
!
Always clean equipment thoroughly before first use. Clean unit daily.
CLEANING
Содержание Cyclone CO11-G
Страница 17: ...Notes 17 ...
Страница 18: ...Notes 18 ...
