Bugbox
UM-16 R5.0
Page 24 of 48
Bugbox User Manual
Ezee Sleeve overview
The Ezee Sleeves consists of a sleeve and a cuff. There are 3 sizes of Ezee Sleeve available; small,
medium and large. See section 7.4.2 for ordering details.
The sleeve attaches to the glove port via 2 O-rings. The cuff is then attached to the sleeve via an O-
ring. Note: The workstation should not be used without the Ezee Sleeves attached.
Entering the workstation chamber using the Ezee Sleeves
To enter the workstation via the Ezee Sleeves;
Set the glove port selector switch (Figure 11) to the correct position for the desired hand entry
(Figure 14).
Hold the desired Ezee Sleeve cuff with the opposite hand.
Supporting the Ezee Sleeve cuff, push the desired hand through the cuff of the Ezee Sleeve.
Figure 15 shows this procedure;
Figure 15: Entering the cuffs of the Ezee Sleeves
Repeat the procedure for the other hand (if both hands are to enter the workstation
chamber).
Press and hold the vacuum pedal with your foot (item 1 in Figure 12) until the internal gas
volume in the sleeves has been evacuated (the sleeves will now be tight around your arms),
then remove your foot from the vacuum pedal.
Repeat the vacuum process to remove oxygen from the Ezee Sleeves.
Unscrew the glove port cover knob by turning it anti-clockwise (counter-clockwise).
