Baker Hughes Druck Dry TC 165, Инструкция по эксплуатации

Страница: 19 / 58

Copyright 2013 Baker Hughes Company.
English–Dry TC / Liquid TC Temperature Calibrators | 11
4.3.4 Surface Insert
The surface insert is used for calibrating surface temperature sensors. The surface insert is
hollow in construction. When installed, the top portion of the surface insert protrudes above the
dry block.
Figure 6: Surface Insert
The additional holes in the border, see Figure 6 item 2, are for external reference sensors. This
allows the exact temperature of the surface insert to be measured.
The two threaded boreholes in the border are for the accompanying exchange tool.
4.3.4.1 Installation
1. The surface insert is inserted into the dry block using the exchange tool, see Figure 6 item 3.
2. Centre the surface insert so that there is an even air gap between the surface insert and the
dry block.
4.3.4.2 Removal and Cleaning
1. Allow the calibrator cool before the surface insert is removed.
2. Pull the surface insert out of the dry block with the help of the exchange tool, see Figure
6
item 3.
3. Clean the surface insert and the dry block to prevent inserts from getting stuck in the dry
block.
4.3.4.3 Application Tips
When using an external reference sensor, insert the sensor into the borehole so that its
measuring element is situated under the middle of the calibration surface.
4.3.5 Micro Bath
The micro bath is used for calibrating sensors with special shapes or dimensions. Direct contact
between the sensor and the calibration liquid ensures excellent heat transfer.
1 Surface insert.
2 External sensor bore holes:
1 × 3.0 mm (0.118″)
1 × 3.1 mm (0.122″)
1 × 4.5 mm (0.177″)
3 Insert exchange tool.
WARNING
Wear safety goggles. Calibration liquid may be ejected when
working with the micro bath. Always wear safety goggles when handling
calibration liquids.
3
2
1