5
10
HOT PLATE
HOT PLATE
GAS CONNECTION - The gas inlet line size of this appliance is 3/4" NPT. For proper operation, the gas
supply service line must be the same size or greater than the inlet line size of the appliance. The gas
line size must not be reduced at any point along the supply line.
MANUAL SHUT - OFF V ALVE - A gas pressure regulator and a contractor-supplied shut-o valve must be
plumbed in the gas service line ahead of the appliance in a physical location where it can be reached
quickly in the event of an emergency .
INSTALLATION - GAS STANDARDS AND CODES
1. The appliance and its individual shut o valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressure in excess of 1/2 psi (3.45 kPa).
2. The appliance must be isolated from the gas supply piping system by closing the individual manual
shut-o valve during any pressure testing of the gas supply piping system at test pressures equal to or
less than 1/2 PSI.
IMPORTANT - The installation of this appliance must conform to local codes or, in the absence of local
codes, with the National Fuel Gas Code ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149-1,
or the Propane Installation Code, CAN/CGA-B149-2 as applicable, incluiding:
B
C
G
F
E
C
D
A
A. Gas pressure regulator
B. 90º Street elbow
C. Adapter (must be 3/4" male pipe thread)
D. Flexible connector
E. Manual gas shut-off valve
F. 3/4" gas supply
G. Use pipe-joint compound
H. Step down regulator
H
LP GAS
A. Gas pressure regulator
A
D
C
E
F
G
C
B
GAS
B. 90º Street elbow
C. Adapter (must be 3/4" male pipe thread)
D. Flexible connector
E. Manual gas shut-off valve
F. 3/4" gas supply
G. Use pipe-joint compound
NATURAL
TO REPAIR, TO GET ACESS, FOLLOW THE INSTRUCTIONS
1 - Lift the top grates
2 - Take off the rest plate fixer screws
3 - Take off the rest plate
4 - Take off the knobs
5 - Take off the panel fastening screws
6 - Take off the panel
1 - TOP GRATE
2 - REST PLATE FIXER SCREW
3 - REST PLATE
4 - KNOB
5 - PANEL SCREW
6 - PANEL
