Baja motorsports WR200, Инструкция по сборке

Страница: 7 / 20

7 — English
© 2010 Baja, Inc. All Rights Reserved.
ASSEMBLY
INSTALLING REAR FENDER

Lift rear fender into position and align holes in fender with
holes in fender brackets.

Install bolts and nuts. Tighten securely. Torque to 7 ft.lbs.
(9.5 Nm).
VERIFY TIRE PRESSURE

Check the air pressure of the tires and inflate as needed
to the proper amount.
NOTE: Tire pressure should only be measured or
adjusted when tires are cold.
Recommended Pressure
12 psi (82.7 kPa)
WARNING:
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing serious
personal injury.
WARNING:
Maintaining correct air pressure in the tires is very impor-
tant. Too little pressure could allow the tire to rotate off
the wheel rim. Too much pressure could cause the tire to
burst. Failure to maintain correct air pressure in the tires
could cause problems with vehicle operation and stability,
causing serious personal injury.
TIGHTEN FRONT SHOCK BOLTS

Tighten front shock bolts securely.

Torque to 35 ft.lbs. (47.5 Nm).
NUT BOLT
FENDER
SHOCK
BOLTS
TIGHTEN JACKSHAFT NUT

Tighten jackshaft nut.

Torque to 60-80 ft.lbs. (81.3-108.5 Nm).
JACKSHAFT
NUT