WASHING YOUR ATV
With some care, your ATV can be washed in a similar manner to washing an
automobile.
Note: Avoid spraying or allowing water to flow over the following places:
· Ignition switch
· Spark plug
· Fuel tank cap
· Carburetor
Use a garden hose at low pressure to remove the majority of dirt or other
debris. Hand wash your ATV with mild soap or detergent and water. Try to
thoroughly remove all dirt and debris without excessive water pressure, even
at remote areas such as between engine cooling fins, linkages or mounting
brackets. Cloth rags, washing mitts or cleaning brushes can be used. Be
careful with brushes as they may scratch plastic or painted surfaces. Rinse
the ATV thoroughly with clean water. Dry all areas using a chamois or soft
absorbent cloth.
INSPECTION AFTER CLEANING
Remove the rags or wrapping from the exhaust pipe. For extended life of
your ATV, lubricate according to GENERAL LUBRICATION section.
Follow the procedures in the INSPECTION BEFORE RIDING section to check
your ATV for any problems that may have occurred during your last ride.
WARNING
Operating the ATV with wet brakes could be hazardous.
Wet brakes may not provide as much stopping power as dry brakes. This
could lead to an accident.
Test your brakes after washing the ATV, riding at a slow speed. If
necessary, apply brake several times to let the friction dry out the linings.
CLEANING PROCEDURE
