58
DRIVE CHAIN CLEANING AND OILING
Clean and oil the chain as the following:
Steam cleaning, high-pressure washers, and certain solvents can damage the
drive chain. Use only kerosene to clean the chain. Wipe it dry, and thoroughly
lubricate it with SAE 30~50 motor oil. Do not use any other lubricants on the
drive chain.
Adjusting the Drive Chain
The drive chain should be adjusted while all four tires are on the ground and make
sure there is 10~20 mm (0.39 ~ 0.79 in) of slack, as shown above. If the vertical
deflection exceeds 20mm (0.79 in), adjust the chain slack.
WARNING
Failing to inspect the drive chain slack before each use of the ATV could be
hazardous.
Too much chain slack could cause the chain to come off the sprockets,
resulting in an accident or serious damage to the ATV.
Inspect the drive chain slack before each use.
You can adjust the drive chain as the following:
1. Loosen the hub stopper bolt (a) and two axle hub
bolts (b).
2. Fit the chain adjustment staff (c) into the screw and
pass the chain adjustment staff through the driven
sprocket holder (d) holes.
3. To adjust the chain, push the ATV forward to loosen
and backward to tighten.
4. When the proper adjustment has be achieved tighten
the two axle hub holder bolts and hub stopper bolt
to the specification:
Axle hub holding bolt: 40Nm (4.0 m-kg, 29 ft.lb)
Hub stopper bolt: 12 Nm (1.2 m-kg, 9 ft-lb)
5. Remove the chain adjustment staff.
10~20 mm (0.39~0.79 in)
a b
c
d
Содержание BA150-2
Страница 16: ...16...
Страница 72: ...72 Baja 150 Circuit Diagram...
Страница 76: ...76 Baja INC P O Box 61150 Phoenix AZ 85082 Tel 602 443 9180 Toll Free 888 863 2252...