4
Tie all wires away from sharp, hot, and/or rotating components.
Re-torque all the fasteners after 100 miles.
Your install is now complete! Thank you for choosing Baja Designs.
7.
Locate the battery box in the
driver side rear wheel well. Unclip
the lid by removing the three
fastening clips.
8.
Route the RTL harness battery
leads through the back panel
opening. Using a 10mm socket,
attach the ring terminals to the
battery.
9.
Remove the center console by
removing each plastic fastener
around the perimeter.
10.
Remove the rear vent cover, by
taking out the 3 plastic
fasteners.
11.
Route the harness from the
battery through the back panel
opening. Route the RTL leads
through the vent opening and
up the driver side B-Pillar.
Route the switches down the
center console up to the dash.
12.
Remove the plastic splice
connector housing from the
bullet connector on both taillight
leads.
13.
Connect the taillight leads to
the splice adapter harness.
Yellow to Yellow & Red to Red.
14.
Finish routing the switches to
the dash. Mount in the stock
location.
7.
8.
9.
10.
11.
12.
Splice
Adapter
RTL
Switches
Battery
14.
13.
