INTRODUCTION
I-E96-418A
2 - 1
SECTION 2 - INSTALLATION
INTRODUCTION
This section explains how to install the Plant Loop Termination
Unit (NTPL01). The installation procedure covers handling,
cable connection and physical installation.
SPECIAL HANDLING
Observe these steps when handling electronic circuitry:
NOTE: Always use Bailey's Field Static Kit (P/N 1948385A1 - con-
sisting of wrist straps, ground cord assembly, and alligator clip)
when working with the modules. The kit connects a technician and
the static dissipative work surface to the same ground point to pre-
vent damage to the modules by electrostatic discharge.
1.
Use an Antistatic Bag.
Keep the modules in the antistatic
bag until you are ready to install them in the system. Save the
bag for future use.
2.
Ground Bags Before Opening.
Before opening a bag con-
taining an assembly with CMOS devices, touch it to the equip-
ment housing or a ground to equalize charges.
3.
Avoid Touching Circuitry.
Handle assemblies by the
edges; avoid touching the circuitry.
4.
Avoid Partial Connection of CMOS Device.
Verify that all
devices connected to the modules are properly grounded before
using them.
5.
Ground Test Equipment.
6.
Use an Antistatic Field Service Vacuum.
Remove dust
from the module if necessary.
7.
Use a Grounded Wrist Strap.
Connect the wrist strap to
the appropriate grounding plug on the power entry panel. The
grounding plug on the power entry panel must be effectively
connected to the earth grounding electrode system through the
DC common bus.
UNPACKING AND INSPECTION
1. Examine the termination module immediately for any ship-
ping damage.
2. Notify the nearest Bailey Controls sales office of any
damage.
