Bailey Approach Advance 615 2017, Руководство пользователя

Страница: 43 / 193

41
THE W
A
TER S
Y
STEM
ADVANCE WATER SYSTEM
Advance Models have an onboard fresh water
tank located either underneath the bed or
within a bunk. Depending on the model The
waste water tank is installed underneath the
floor between the chassis members.
The Advance range uses a Whale submersible
pump found within the onboard fresh water
tank.
The pump is already fully installed and will run
when the pump is turned on via the control
panel and a tap within the motorhome is
opened.
The pump should be inspected and cleaned at
frequent intervals. Ensure the water supply is
free of debris this will reduce the likelihood of
the pump clogging.
These pumps are sealed units, so no further
maintenance is required.
Winterizing: To protect against damage, as a
result of freezing, drain the entire water system
when not in use.
Submersible Water Pump (within tank)
Filling With Fresh Water
To fill the onboard fresh water tank: connect
the water hose to an external tap, then feed the
other end into the fresh water filler.
Monitor the water level inside the tank from the
control panel.
The water system should now be primed.
Pressure Switch
Your pressure switch is factory set and should
not normally require adjustment. However,
adjustment may be required if the power supply
voltage has varied from the previous setting,
either due to battery drainage or higher voltage
being supplied when the battery charger is
operating. In the event that your pump doesn’t
switch off when you close the taps or it pulses
on and off rapidly when the taps are fully open,
follow these guidelines to re-adjust the pressure
switch setting.
1. Ensure the system, including the heater is
full of water and all taps are closed.