Technical Specifications
Operating voltage / Nom. spanning / Betriebsspannung / Tension nominale
AC 100V-240V 50-60Hz
Beam angle / Stralingshoek / Abstrahlwinkel / Angle de diffusion
110°
Operating temperature / Omgevingstemperatuur / Betriebstemperatur / Température ambiante
-20 ~ 40
°
IP Rating / IP Waarde / Schutzart / Protection IP
IP65
Manual - Handleiding
Bedienungsanleitung - Manuel d’instruction
LED Wallpack
www.bailey.nl
A
A
A
B
A
B
B
B
B
B
A – Tapped holes with metal screw cap suitable for TP Watertight connector (Included)
B – Mounting holes
360mm
235mm
190mm
EN
Caution
•
Disconnect power before installation and servicing.
•
Make sure the supply voltage is the same as the rated luminaire voltage.
•
The product may only be assembled and fitted by a qualified electrician.
•
Mounting surface must be specified to properly support the weight of the luminaire.
•
Suitable for both internal and external use.
•
Suitable for wall mounting only.
Installation
1.
Switch off the power supply. Open the luminaire by removing the 2 screws on the side. Line up back plate and mark
mounting holes (B) onto surface. Mount securely (gaskets included) and ensure luminaire is installed tight to mounting
surface. Optional:
- Remove front cover by disconnecting connector
- Use metal bracket for wall mounting (included)
2.
Select a cable entry and remove the screw cap from the desired mounting hole (A), place watertight connector (included)
and connect power cable to luminaire: Blue to N, Brown to L, Green/Yellow to Ground. If using a junction box, bring the
circuit wires through the rear hole into the luminaire.
3.
Close the front cover and tighten the screws securely and make sure wiring is not pinched. Apply silicon sealant (not
provided) to seal all holes in luminaire housing and between housing and mounting surface to weather-proof your outdoor
installation.
Safety – Maintenance - Environment
•
Do not cover the product. Do not attach other items to the product. Store and install the product out of the reach of
children. Only use the product when it is working perfectly.
•
Do not touch the product in the event of a fault or breakdown. Immediately switch off the product and disconnect the
power supply.
