Baileigh WR-84V-ATC, Руководство оператора

Страница: 19 / 56

17
17
Preparing the Vacuum Pump
1. Verify that the label on the pump indicates the
correct power requirements, 220V, 3ph, 20A.
2. Place the vacuum pump at the rear of the
table within reach of the main vacuum port.
Leave a minimum of 6” (153mm) of open
space on all side of the pump for air flow and
service access.
3. Remove the hole plug and apply Teflon tape
to the threaded nipple and screw the filter
assembly into the hole of the pump as shown.
4. Route the Push the end of the vacuum hose
from the table onto the filter assembly fitting,
and secure with two hose clamps.
Plug
Filter
Assembly