Baileigh TS-1248P, Руководство оператора

Страница: 36 / 104

32
32
BLADE INSTALLATION
1. Disconnect and lockout power to the saw!
2. Raise the arbor all the way up, and remove the
table insert and blade guard/riving knife, depending
on what is installed.
3. Use the arbor wrenches to loosen and remove the
arbor nut, flange, and blade. The arbor nut has right
hand threads; turn it counter-clockwise to loosen.
4. Install the new blade, flange and arbor nut on the
arbor, with teeth facing the front of the saw.
5. Securely tighten the arbor nut and the flange
against the blade using the wrenches included with
the saw. DO NOT overtighten.
6. Re-install the blade guard/riving knife and the table
insert.
WARNING:
Blades are dangerously sharp. Use extreme caution when
working with or around the blade. Wear proper safety protection such as heavy
gloves.
WARNING:
Turn the power switch “OFF” and unplug the power cord
from its power source when changing the saw blade.
When replacing blades, check the thickness stamped onto the riving knife. You must
select a blade with a kerf width larger than the thickness of the riving knife. Thinner
blades may cause the workpiece to bind during cutting.
USE ONLY 12
″diameter blades with 1″arbor holes, rated at or higher than 3800 rpm.
CAUTION:
After changing a saw blade, always check that the Riving knife
or Blade Guard is correctly set!