Baileigh TS-1248P, Руководство оператора

Страница: 24 / 104

20
20
Extension
Table 52” Models
1. With help of an assistant, install the extension
table hand tight until all hardware is installed
and the table is both flush and flat with the
main table.
2. Thread (2) M10-1.5 x 25 hex bolts with 10mm
flat washers onto the right side of the main
table (A).
3. Place the extension table between the rails and
slide the table slots over the bolts installed into
the main table.
4. Fasten the front rail to the extension table with
(3) M8-1.25 x 25 flat head screws, 8mm flat
washers and M8-1.25 hex nuts (B).
5. Fasten the rear rail to the extension table with
(3) M8-1.25 x 25 cap screws, (3) 8mm lock
washers, (6) 8mm flat washers, and (3) M8-
1.25 hex nuts.
6. Align the main table and extension table with a
straightedge (C), and then tighten all of the
mounting fasteners.
7. Thread a 3/8-16 hex nut (D) onto each foot,
and then thread the feet into the bottom of the
support legs.
A
B
C
D