Baileigh SD-255, Руководство оператора, Страница: 23 / 32

21
21
TROUBLESHOOTING
FAULT REMEDY
Sanding belt clogs too quickly 1. Sanding belt grit too fine.
2. Too much material being removed in one
pass.
3. Dirty piece part suction.
4. Insufficient dust suction.
5. P iece part contains too much moisture.
Rounding occurs at edges or workpiece. 1. Too much material being removed in one
pass.
Uneven thickness of right and left sides of
piece part after sanding. 1. Sanding drum is not parallel to the table.
2. Uneven wear on sanding belt
Stock slips on conveyor belt. 1. Too much material being removed in one
pass.
2. Sanding belt grit too fine.
Shiny spots on sanded piece part. 1. Conveyor belt is too smooth.
2. Conveyor belt tension is insufficient
3. Excessive dust accumulated on
conveyor belt surface.
Marks on sanded surface of piece part. 1. Sanding belt is too worn.
2. Sanding height set incorrectly
3. Sanding belt damaged.
Conveyor belt does not run smoothly, or
stops. 1. Insufficient conveyor belt tension.