Baileigh IP-208, Руководство оператора

Страница: 25 / 44

23
23
1. UNPLUG OR DISCONNECT PLANER FROM
POWER SOURCE AND LOCK OUT POWER.
2. Place gauge block under the cutterhead.
3. Raise the table and rotate the cutter head until the
blade just contacts the gauge block.
Infeed Roller
1. Place gauge block under the infeed roller. (Fig.
23).
2. Loosen nut (2) and turn screw (1). This will make
the infeed roller move upwards, or downwards.
3. Make infeed roller touch the top of gauge block.
4. Once adjusted, turn the nut tightly (2), and replace
screw (1).
5. The same procedures apply for the other end.
Outfeed Roller
1. Place gauge block under outfeed roller. (Fig. 24)
2. Loosen nut (3) and screw (4). This will allow for the
outfeed roller to move upwards, or downwards.
3. Make the roller touch the top of gauge block.
4. When adjustments have been finished, tighten nut
(3), and replace screw (4).
5. The same procedures apply for the other end.
WARNING:
Knife inserts are
dangerously sharp. Use extreme caution
when working with or around the knife
inserts.
Fig. 22
Fig. 23
Fig. 24