Baileigh DP-4016B, Руководство оператора

Страница: 26 / 40

24
24
Worktable Adjustment
The worktable may be adjusted for elevation and tilting.
Note: Always remove all material, tools and vises before adjusting the worktable.
Elevation and Rotation
1. Support the worktable and loosen the clamping bolt (C).
2. Use the crank handle (D) to lift or lower the table as desired.
3. Hold the table in position and tighten the clamping bolt (C).
Tilt
1. Support the worktable and loosen the tilting nut (E).
2. Use the scale at the back of the table as an indicator of the degree of tilt.
3. When the table is at the desired tilt angle, hold in position and tighten the nut (E).
Depth Stop
This drill press comes with a depth stop adjustment
for use when drilling.
1. Loosen the depth collar lock knob (A).
2. Secure the material you will be drilling onto the drill
press table.
3. With the desired bit installed, lower the spindle
until the tip of the bit just touches the material you
will be drilling. Hold the spindle in this position.
4. Turn the depth collar to the desired depth indicated
by the scale on the collar (B).
5. Secure the collar by tightening the lock knob (A).
6. Remove the material and test the depth stop by
measuring how far the spindle travels when the handles are rotated.
B
A